Clean tools with paint thinner or mineral spirits maintenance procedures proper maintenance starts with visual inspection.
Sikkens cetol door and window sanding before final coat.
Available as a clear satin clear gloss or 4 ready mix colors in satin.
Sikkens proluxe cetol door and window is a premium translucent exterior stain whose alkyd high solids formulation offers optimum protection and a distinctive look for these unique areas.
Apply one coat of cetol door window.
Let surface dry a minimum of 24 hours.
Do not apply cetol door window over other coatings.
Working with cetol door window application do s apply when the surface and air temperature is 50 f 10 c to 95 f 35 c stir well before using do not apply in direct sunlight saturate all end grains nail holes and cracks in the wood.
Apply second coat of cetol door window 5.
Dries to touch in approximately 12 hours.
Brush on the second coat following the same order and let it dry overnight.
Apply a third coat of cetol i.
Clean tools with mineral spirits.
Old damaged coatings must be completely removed before application of cetol door window.
This process was repeated once more before applying the final coat of.
Then the door was lightly sanded and cleaned again before applying a coat of sikkens cetol 23.
Let surface dry for minimum of 24 hours 6.
Coat all sides of door.
Let surface dry for minimum of 24 hours 4.
Apply a third coat of door window wood finish.
Apply in the direction of the grain.
Dries to recoat in 24 hours additional coat may increase these times.
Clean tools with mineral spirits.
Apply 1st coat of cetol door window 3.
A more resilient alternative to exterior varnishes and polyurethanes.
Apply 3rd coat of cetol door window 7.
Application do s apply when the surface and air temperature is 50 f 10 c to 95 f 35 c stir well before using saturate all end grains nail holes and cracks in the wood.
Wait 7 days before using furniture.
After sanding the door it was refinished with a base coat of sikkens cetol 1.
In order to restore this home s front door to its original condition our team at monk s completely stripped the door and sanded it to the bare wood.
Let surface dry for minimum of 24 hours 6.
Application do s for cetol i and cetol 23 plus apply when the surface and air temperature is 50 f 10 c to 95 f 35 c stir before using saturate all end grains nail holes cavities and.
It is always recommended to perform a three 3 coat color and sheen test sample of the wood.
Apply 2nd coat of cetol door window 5.
You don t want to sand through to bare wood dust the door and wipe it down with a tack cloth.
Working with cetol door window preparation procedures new weathered uncoated wood sand door and window surfaces with 80 120 grit sandpaper prior to application of cetol door window.
Apply third coat of cetol door window 7.
The best method to prepare vertical wood surfaces is to sand with 80 120 grit sandpaper.
However an alternate to sanding for preparation is listed below.
Let surface dry a minimum of 24 hours.
Apply final coat and reattach hardware photo by kit latham.
